Skip to content
Speaker Tester

Midrange · Speech

500 Hz Test Tone

500 Hz is one of the core frequencies on a hearing test and sits in the heart of the vowels in speech. It is an easy, safe tone for comparing two ears or two speakers.

  • Free
  • No download
  • No sign-up
  • Audio stays on your device

Loading…

Test tone

500Hz

B4 +21 cents · Sine wave

Waveform
Output

Sine is the pure test tone. Square, triangle and sawtooth add harmonics above 500 Hz, which makes rattles and distortion easier to hear.

20%

Start quiet. Lower your device volume before you press play, then raise it slowly. Test tones are pure and can be louder than music at the same setting.

500 Hz in speech and hearing tests

Vowel sounds carry most of their energy between about 300 and 1000 Hz, so 500 Hz is central to how loud speech sounds. On an audiogram, 500, 1000 and 2000 Hz are often averaged together to describe how well someone hears conversation.

Because every speaker and headphone can reproduce 500 Hz easily, it is a good tone for checking balance. Play it quietly, switch between Left and Right and listen for a difference. If one headphone ear is noticeably quieter, swap the headphones around: if the quiet side follows the headphones, they are the cause; if it stays with your ear, consider a hearing check.

Checking a midrange driver

In three-way speakers, the midrange driver usually covers roughly 300 Hz to 3 kHz, so 500 Hz should come cleanly from that driver. Put your ear close to each driver in turn while the tone plays to confirm which one is working. A silent midrange with working woofer and tweeter is a classic failure after a speaker has been overdriven.

B4 (493.9 Hz) is just below this tone. Many car horns use two notes in the 400–500 Hz range, which is why they cut through traffic noise so well.

Frequently asked questions

Is 500 Hz used in hearing tests?

Yes. Standard audiograms test 500 Hz along with 250, 1000, 2000, 4000 and 8000 Hz. This page can compare ears but can’t measure hearing levels.

Which speaker driver plays 500 Hz?

In two-way speakers, the woofer. In three-way speakers, the midrange driver.

Why does one ear sound quieter at 500 Hz?

It could be the headphones, the fit, earwax or your hearing. Swap the headphones around to see whether the difference follows the headphones or your ear.

Keep testing

See All Tests

Want to check everything in one go? Run the full speaker test on the homepage.