Skip to content
Speaker Tester

Midrange · Reference

1 kHz Test Tone (1000 Hz)

1 kHz is the audio world’s reference tone. It is used for line-up and calibration in studios and broadcasting, to define loudness scales, and for the familiar censor “bleep”.

  • Free
  • No download
  • No sign-up
  • Audio stays on your device

Loading…

Test tone

1kHz

B5 +21 cents · Sine wave

Waveform
Output

Sine is the pure test tone. Square, triangle and sawtooth add harmonics above 1 kHz, which makes rattles and distortion easier to hear.

20%

Start quiet. Lower your device volume before you press play, then raise it slowly. Test tones are pure and can be louder than music at the same setting.

Why 1000 Hz is the reference

Engineers needed a standard frequency that every device can reproduce and ears hear well, and 1 kHz became that reference. Broadcast and studio line-up tones are 1 kHz sine waves at a fixed digital level, typically −18 dBFS in Europe (EBU) and −20 dBFS in the US (SMPTE). Loudness scales are anchored here too: the phon scale of perceived loudness is defined at 1 kHz, and A-weighting curves are normalised to 0 dB at 1 kHz.

Speaker sensitivity specs are often measured with a 1 kHz tone or a band centred on it, and the TV censor bleep is traditionally a 1 kHz tone.

Using a 1 kHz tone at home

Level matching: play the tone, switch between Left and Right, and adjust balance until both sides sound equally loud from your seat. With a phone sound-level meter app you can also match two speakers more precisely.

Clarity checks: on a phone or laptop, 1 kHz should sound bright and clean. If it sounds dull or buzzy, the grille may be blocked by lint or water, or the speaker may be damaged. If you are setting up gain on a car amplifier, use a proper test track and a meter rather than this tone alone, because the correct level depends on your head unit’s output.

Frequently asked questions

What is a 1 kHz test tone used for?

Calibration and level matching in studios and broadcasting, measuring speaker sensitivity, and checking that both channels are equally loud.

Why is the censor bleep 1000 Hz?

It was the standard reference tone already present in broadcast equipment, and it is clearly audible over speech.

Can I calibrate my speakers with this tone?

You can match left and right levels by ear or with a sound-level meter. For subwoofer and room calibration, use pink noise or your receiver’s calibration system.

Keep testing

See All Tests

Want to check everything in one go? Run the full speaker test on the homepage.