Skip to content
Speaker Tester

Device · Phone

Phone Speaker Test

Hold your phone sideways and run the sequence. It checks that both speakers work, finds where the bass starts, and helps tell a blocked grille from a damaged speaker, all from your mobile browser.

  • Free
  • No download
  • No sign-up
  • Audio stays on your device

Loading…

6 steps · about 46 seconds

Press play to run every test

Each speaker, the bass floor, muffling, range and crackle on your phone.

  1. 1Left speaker4 s · Hold the phone sideways. Sound from one end only — on stereo phones the earpiece is one channel.
  2. 2Right speaker4 s · Sound from the other end. A single-speaker phone plays both steps from the bottom.
  3. 3Low-end sweep 80–600 Hz12 s · Silence at first, then the tone appears around 200–400 Hz. That’s normal for a phone.
  4. 4Muffle check at 1 kHz5 s · A clear, bright beep. If it sounds dull or buzzy, the grille may be blocked by lint or water.
  5. 5Full sweep 20 Hz–20 kHz16 s · Smooth rise from the low mids to a thin high whistle.
  6. 6Pink noise5 s · Even hiss with no crackle or rattle at moderate volume.
20%

Start quiet. Lower your device volume before you press play, then raise it slowly. Test tones are pure and can be louder than music at the same setting.

Which speaker is which on a phone?

Most recent iPhones and many Android phones have stereo speakers: one at the bottom edge and the earpiece at the top doubling as the second channel. Hold the phone in landscape and the system assigns left and right according to the orientation, so the left step should come from whichever end is on your left. On a phone with a single speaker, both steps come from the bottom, which is expected.

The earpiece speaker is much smaller and usually quieter, with less bass, so a slight imbalance is normal. A completely silent earpiece during the left or right step, while calls still sound fine, usually means the phone is in a mode that disables stereo, such as mono audio in the accessibility settings.

Muffled, quiet or crackling phone speaker

A muffled sound that came on suddenly is usually lint, dust or water in the grille. Use the 1 kHz muffle step: it should be a clear, bright beep. If it sounds dull, brush the grille gently with a soft dry toothbrush and run the speaker cleaner, which plays a 165 Hz water-eject tone. A case or screen protector covering the speaker cut-outs causes the same symptom.

Phone speakers can’t reproduce deep bass; on the low-end sweep the tone typically appears between 200 and 400 Hz. Crackle or buzzing at moderate volume, especially after a drop, points to a torn speaker membrane. Restart the phone and test again to rule out software, then contact the manufacturer or a repair shop if it persists.

Frequently asked questions

How do I test my phone or iPhone speaker?

Open this page on the phone, turn off silent mode, hold it sideways and press Play, then compare what you hear with each step’s description. On an iPhone, flip the Ring/Silent switch or turn off Silent mode, disconnect AirPods and other Bluetooth devices, and take off the case. On Android, raise the media volume, not just the ringer volume. Recording a short voice memo and playing it back is a quick extra check.

How do I tell if my phone speaker is broken?

A broken phone speaker crackles, buzzes or distorts at normal volume, or stays silent even with Bluetooth disconnected and silent mode off. First rule out simple causes: low media volume, a connected Bluetooth device, a case covering the grille, or lint or water in the grille. Then play the test above at medium volume. If the sound is still distorted after cleaning and restarting, the speaker is likely damaged and a repair shop should check it.

Why is my phone speaker muffled?

Usually lint, dust or water in the grille, or a case covering it. Brush the grille gently, remove the case and run the speaker cleaner water-eject tone a couple of times.

Why can’t I hear the test on my iPhone?

Web audio follows the silent switch. Flip the Ring/Silent switch (or turn off Silent mode on newer models) and check that no Bluetooth device is connected.

Does my phone have stereo speakers?

Run the left and right steps in landscape. If each comes from a different end, it is stereo. If both come from the bottom edge, it has a single speaker.

How do I make my phone speaker louder?

Turn up the media volume, clear anything blocking the grille, and check that no setting is holding the level down. Take off the case, gently clean the grille with a soft, dry brush, and disconnect Bluetooth so sound isn’t going to another device. Check that no volume limit or EQ preset is lowering the output, and point the speaker towards you or set the phone on a hard surface. If water muffled it, run the speaker cleaner.

Keep testing

See All Tests

Want to check everything in one go? Run the full speaker test on the homepage.