Skip to content
Speaker Tester

Device · Car audio

Car Speaker Test

Connect your phone to the car over Bluetooth, CarPlay, Android Auto or AUX, sit in the driver’s seat and run the sequence. It checks each side, the center image, polarity, rattles, the sub and the full range in about a minute.

  • Free
  • No download
  • No sign-up
  • Audio stays on your device

Loading…

8 steps · about 64 seconds

Press play to run every test

Balance, center image, polarity, rattles, sub blend, range and noise for your car.

  1. 1Left side5 s · Only the driver- or passenger-side doors on the left. If the rear plays too, that’s normal with the fader centered.
  2. 2Right side5 s · Only the right-hand doors. A quiet side points to the balance setting, a wire or a blown speaker.
  3. 3Center image5 s · From the dashboard in front of the driver’s seat, not from one door.
  4. 4Out of phase4 s · Thinner and vaguer than the center step. If it sounds fuller, one door speaker is wired backwards.
  5. 5Rattle check at 50 Hz8 s · A steady deep hum. Listen for buzzing door cards, the parcel shelf, mirrors or loose items.
  6. 6Bass sweep 20–200 Hz14 s · Rising bass. Note boomy spots and the point where the sub hands over to the doors.
  7. 7Full sweep 20 Hz–20 kHz18 s · Smooth from bass to treble. Dash tweeters take over above ~3 kHz.
  8. 8Pink noise5 s · Even hiss from all speakers, with no crackle when you go over bumps or tap the doors.
20%

Start quiet. Lower your device volume before you press play, then raise it slowly. Test tones are pure and can be louder than music at the same setting.

Use balance and fader to test all four corners

A browser can only send two channels, left and right, so the front and rear speakers on each side play together. To isolate one speaker, use the car’s own controls: during the Left side step, move the fader fully to the front to hear the front-left door, then fully to the rear for the rear-left. Repeat on the Right side step. A speaker that stays silent in its corner is disconnected, blown or has a broken wire in the door hinge loom, which flexes every time the door opens.

If the balance is centered but one side is clearly louder, check the head unit’s per-seat or “driver focus” setting first. Many cars ship with sound-field presets that delay and lower the speakers nearest the driver, which makes a perfectly good system sound lopsided from the passenger seat.

Rattles, polarity and subwoofer problems

The 50 Hz rattle step is where most car problems show up. Buzzing usually comes from a loose door card clip, the plastic window trim, the parcel shelf, a licence-plate frame or simply coins in the door pocket. Have someone press on panels while the tone plays; when the buzz stops, you have found it. Foam tape or felt behind the panel fixes most of them.

If the out-of-phase step sounds fuller than the center step, one door speaker is wired backwards, which is common after an aftermarket install. Bass will sound thin and the image will float. Swap the two wires on that one speaker. On the bass sweep, a big gap between the sub and the doors means the crossover or sub phase switch needs adjusting; a huge peak around 50–70 Hz is normal cabin gain and can be tamed with the sub level.

Frequently asked questions

How do I test my car speakers with my phone?

Connect the phone over Bluetooth, CarPlay, Android Auto or an AUX cable, open this page and press Play. Use the car’s balance and fader during the left and right steps to hear each speaker on its own.

Why is one car speaker not working?

Check the balance and fader first, then any “driver focus” sound setting. If the speaker is still silent, the cause is usually a broken wire in the door hinge loom, a loose connector behind the door card or a blown speaker.

How do I know if my car speakers are bad?

Bad car speakers sound distorted, rattly or thin, or one stays silent when you move the balance and fader towards it. Play a test, then use the balance and fader to listen to each speaker on its own. Compare left with right and front with rear: a speaker that crackles, buzzes on bass or sounds muffled next to its partner is probably damaged. Rule out loose door trim first, because it rattles in much the same way.

Why do my car doors rattle with bass?

Low frequencies vibrate loose trim clips, window seals and items in the door pockets. Play the 50 Hz step, press on panels to find the buzz, and fix it with foam tape, felt or new clips.

Does Bluetooth affect a car speaker test?

Only slightly. Media Bluetooth (A2DP) is fine for these tests. If the sound is thin, mono and band-limited, the car has connected for phone calls only; reconnect it as a media device.

What is a good song to test speaker quality?

Test tones and sweeps reveal problems more reliably than any song, because music changes constantly and hides missing frequencies. Run a test first to check each speaker, the phase and the frequency range. Then play well-recorded music you know well and listen for deep, controlled bass without boom, clear and natural vocals, crisp cymbals without harshness, and a wide stereo image with instruments placed left, right and center. A lossless or high-quality stream helps.

Keep testing

See All Tests

Want to check everything in one go? Run the full speaker test on the homepage.