Skip to content
Speaker Tester

Low mids · Muddiness

200 Hz Test Tone

200 Hz is where bass turns into midrange. Too much energy here makes sound muddy; too little makes it thin. It is also where the wall behind your speakers can cause a surprising dip.

  • Free
  • No download
  • No sign-up
  • Audio stays on your device

Loading…

Test tone

200Hz

G3 +35 cents · Sine wave

Waveform
Output

Sine is the pure test tone. Square, triangle and sawtooth add harmonics above 200 Hz, which makes rattles and distortion easier to hear.

20%

Start quiet. Lower your device volume before you press play, then raise it slowly. Test tones are pure and can be louder than music at the same setting.

Muddy sound and the low mids

The range from roughly 200 to 300 Hz is where mixes, rooms and speakers most often get “muddy”. Many instruments overlap here, including the body of guitars, piano, cello and voices, and small rooms tend to pile up energy in the same range. The lowest note on a violin, G3, is about 196 Hz, very close to this tone.

If your speakers sound boxy or congested, play this tone and nearby ones such as 150 and 250 Hz. A tone that sounds clearly louder than its neighbours points to a resonance in the cabinet, the shelf the speaker sits on, or the room.

The wall-bounce dip

Sound from a speaker also reflects off the wall behind it. When that reflection arrives half a wavelength late, it cancels the direct sound. For a speaker about 43 cm from the front wall, the cancellation lands near 200 Hz, making this tone sound weak from the listening seat even though the speaker plays it fine.

To test, play the tone and slide the speaker 20–30 cm closer to or further from the wall. If the level changes a lot, you are hearing this boundary effect. Placing speakers either very close to the wall or more than a metre away usually avoids the worst of it. Phone speakers typically only begin to produce sound around this frequency.

Frequently asked questions

Why do my speakers sound muddy?

Too much energy around 200–300 Hz, often from room resonances, speakers too close to corners or a soft surface under the speaker. Compare this tone with its neighbours to find the peak.

Can phone speakers play 200 Hz?

Many phones begin to produce audible sound between 200 and 400 Hz, so 200 Hz may be faint on a phone.

Is 200 Hz bass or midrange?

It is the boundary. Engineers usually call 60–250 Hz bass and 250 Hz–2 kHz midrange, so 200 Hz is the top of the bass range.

Keep testing

See All Tests

Want to check everything in one go? Run the full speaker test on the homepage.