Skip to content
Speaker Tester

Frequency · 20–120 Hz

Subwoofer Test

Sub-bass tones and a slow sweep built for setting up a subwoofer: check how low it goes, whether it blends smoothly with your main speakers, and whether anything in the room rattles.

  • Free
  • No download
  • No sign-up
  • Audio stays on your device

Loading…

Tone

40Hz

Mode
Output
Frequency

Mark where bass appears, and anywhere it dips, booms or rattles.

20%

Start quiet. Lower your device volume before you press play, then raise it slowly. Test tones are pure and can be louder than music at the same setting.

Fixing what you hear

A dip near the crossover usually means the sub is out of phase with the mains. Flip the sub’s phase switch (0°/180°) and re-run the sweep, keeping whichever setting sounds fuller. Big peaks and nulls at specific frequencies are room modes: moving the sub even 30–50 cm along a wall can smooth them out.

If the level drops off sharply at the top of the sweep, your crossover is set too low. If the sub sounds “boomy” and draws attention to itself, it’s too high or too loud.

Frequently asked questions

How do I test my subwoofer?

Play a 40 Hz tone at moderate volume and check that you hear and feel a steady, deep hum from the subwoofer. If there’s nothing, make sure the sub is switched on, its cable goes to the receiver’s SUB or LFE output, and the subwoofer is enabled in the receiver’s speaker setup. Then run the sweep from 20 to 120 Hz: the bass should stay smooth, without rattles, sudden gaps or one note booming much louder than the rest.

What frequency should I set my subwoofer crossover to?

80 Hz is the THX standard and a safe starting point. Use 60 Hz with large floor-standing speakers, and 100–120 Hz with small satellites. Run the sweep after changing it and listen for a smooth handover.

Why does my subwoofer sound louder in some spots?

Low frequencies form standing waves (room modes) that create loud peaks and quiet nulls. Try the “subwoofer crawl”: put the sub at your seat, play the sweep, crawl around the room and place the sub where the bass sounds most even.

Does this test work through a receiver or soundbar?

Yes, as long as the receiver redirects bass to the subwoofer. Most do this automatically when speakers are set to “small”. Browsers output stereo, so the sub receives bass through bass management, not a dedicated LFE channel.

Keep testing

See All Tests

Want to check everything in one go? Run the full speaker test on the homepage.